What Wake on LAN does
Wake on LAN (WoL) is a standard way to switch on or wake a computer by sending it a special network message, called a magic packet. It is built into most network adapters and BIOS/UEFI firmware, but it is usually switched off, and it needs the sender's message to reach the computer's network.
How SystemDesk makes it easy
The awkward part of Wake on LAN has always been the MAC address, the network address of the computer's adapter. SystemDesk removes that step:
- Each computer you sign in on reports its network addresses to your account.
- When you press Wake on LAN for that computer, the app finds its address in your account and sends the signal. You do not type anything.
- If the address is not known yet, the app tells you why, instead of failing silently.
It works for the computers of the account you are signed in with that have connected at least once.
What has to be true
Wake on LAN depends on the computer and its network, not on any software:
- Enable it in the computer's firmware (BIOS/UEFI), often called "Wake on LAN", "Power on by PCI-E" or "Wake on magic packet".
- Enable it in the operating system. On Windows: Device Manager, your network adapter, Power Management, allow the device to wake the computer and only a magic packet. On a Mac: System Settings, Battery or Energy, "Wake for network access".
- Use a wired connection where you can. Many computers do not wake from a sleeping Wi-Fi connection.
- Send the signal from the same local network. A magic packet is a local broadcast. To wake a computer from outside its network you need a device on that network that can send it (an always-on computer or a router that supports it).
After the computer wakes
Once it is awake and SystemDesk is running as a background service, connect as usual with its permanent password. This is the full unattended workflow: unattended access to reach it, Wake on LAN to switch it on.
Questions
Why did nothing happen? The most common reason is that Wake on LAN is not enabled in the firmware or in the network adapter's settings. The second is that the sending device is not on the same network as the computer.
Does it work on a Mac? Yes, on Macs that support waking for network access, usually when connected by Ethernet and plugged in.
Is the wake signal secure? A magic packet only contains the computer's address. It carries no password, which is why you should keep the computer's remote access protected with a strong permanent password and two-factor sign-in on your account.